Related Links
The effect of corona treatment to improve the mechanical properties of nitrocellulose and polyurethane coatings used in wooden furniture | ||
| تحقیقات علوم چوب و کاغذ ایران | ||
| Article 2, Volume 34, Issue 3 - Serial Number 69, November 2019, Pages 326-336 PDF (838.03 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.22092/ijwpr.2019.126034.1538 | ||
| Author | ||
| Hadi Gholamiyan* | ||
| Assistant Professor, Department of Wood and Paper Science & Technology, Faculty of Natural Resources, University of Tehran, Karaj, Iran | ||
| Abstract | ||
| In this study, the effect of corona treatment on improving the durability of nitrocellulose and polyurethane coatings used in the wood furniture industry before and after weathering investigated. The boards made from poplar and beech were coated by an automatic film applicator after corona treatment and accelerated for 30 days in a weathering machine. Then, the contact angle, abrasion resistance, and pull-off adhesion testing to the wood surface coatings were analyzed. The results showed that corona treatment reduced contact angle in wooden species and the highest contact angle reduction found in beech wood. Also, the results of the adhesion test showed that the highest adhesion was related to the polyurethane coating and after weathering, the adhesion of the coatings decreased, but the use of corona treatment, in addition to increasing the adhesion strength before weathering, could significantly improve adhesion after weathering. The results of the abrasion test showed that the wear resistance increased in wooden species due to the coating, and the highest amount observed in the beech-coated with polyurethane. After weathering, wear resistance was reduced in all samples, but using corona treatment increased resistance to abrasion. In general, it can say that the use of corona treatment can significantly (95%) improve the resistance to mechanical properties and durability of coatings before and after weathering and thus increase the durability of the furniture and wooden structures. | ||
| Keywords | ||
| Corona treatment; Contact angle; Abrasion; Adhesion test; Wooden furniture | ||
| References | ||
|
- Acda, M.N., Devera, E.E., Cabangon, R.J. and Ramos, H.J., 2012. Effect of plasma on adhesion properties of wood. Int. J. Adhes. Adhes, 32: 70-75. - Baziar, B., Parsapajoh, D., Khademy, Eslam, H.A., and Hamasi, S.A.H. (2007(. Investigation physical properties of Poplar wood treated with hot linseed oil. Science Agricultural Journal, 13(1): 197-206. - Blanchard, V., Blanchet, P. and Riedl, B., 2009. Surface energy modification by radiofrequency inductive and capacitive plasma at low pressures on sugar maple: An exploratory study. Wood Fiber Sci, 41: 245-254. - Clausen, C., Green, F. and Kartal, S., 2010. Weatherability and Leach Resistance of Wood Impregnated with Nano-Zinc Oxide. Nanoscale Res Lett, 5: 1464-1467. - Fahmy, A., Friedrich, J., Poncin-Epaillard, F. and Debarnot, D., 2016. Plasma polymerized allyl alcohol/O2 thin films embedded with silver nanoparticles, Thin Solid Films 616: 339-347. - Ghofrani, M. and khojasteh khosro, S., 2013. The Effect of Wood Surface Finishing Quality on the Adhesion Strength of Clear Coat. Journal of Color Science and Technology, 4: 339-346. - Gholamiyan, H., Tarmian, A., Doost Hosseini, K. and Azadfallah, M., 2011. The effect of nano particles and common furniture paints on water resistance behavior of poplar wood (P.nigra). Iranian Scientific Association of Wood & Paper Industries, 2(1): 16–26. - Godnjavec, J., Znoj, B., Vince, J., Steinbucher, M., znidarsic, A. and Venturini, P., 2012. Stabilization of rutile TiO2 nanoparticles with glymo in polyacrylic clear coating. Materials and Technology, 46(1): 19-24. - Hui, B., Li, Y., Huang, Q., Li, G., Li, J., Cai, L. and Yu, H., 2015. Fabrication of smart coatings based on wood substrates with photoresponsive behavior and hydrophobic performance. Materials and Design, 84:277–284. - Khojasteh Khosro1, S., Ghofrani, M. and Ganjaee Sari, M., 2015. The effect of adding zinc oxide nanoparticles on color change and adhesion strength of polyurethane coating on wood surface. Iranian Journal of Wood and Paper Science Research. 30 (4): 690-704. - Lukowsky, D. and Hora, G., 2002, Pretreatments of wood to enhance the performance of outdoor coatings. Macromol. Symp, 187: 77-85. - Malekani, M., Khademeslam, H.o., Hosseinihashemi, S.KH. and Zeinaly, F., 2014. Influence of Fungal Decay On Chemi-mechanical properties of Beech wood (Fagus Orientalis). J. of Cellulose Chemistry and Technology, 48 (2): 97-103. - Manevi, G., Ghofrani, M. and Mirshokraei, S.A., 2012. Effects of wood type, moisture content and paint type on adhesion strength of conventional clear paints used in furniture manufacture. Iranian Journal of Wood and Paper Science Research, 27(4): 743-753. - Matini, B. and Tarmian, A., 2013. Improvement of the weathering resistance of wood /polyethylene composite using carbamate derivatives (IPBC) and Thiabendazole preservative materials. Iranian Journal of Wood and Paper Science Research, 28 (1): 123-133. - Nejad, M., Shafaghi, R., Ali, H. and Cooper, P., 2013. Coating of oil-heat treated flooring, BioResources 8(2): 1881-1892. - Podgorski, L., Chevet, B., Onic, L. and Merlin, A., 2000. Modification of wood wettability by plasma and corona treatments, Int. J. Adhes. Adhes. 20(2): 103-111. - Riedl, B., Angel, C., Prégent, J., Blanchet, P. and Stafford, L., 2014. Effect of wood surface modification by atmospheric-pressure plasma on waterborne coating adhesion, BioRes, 9(3): 4908-4923. - Sakata, I., Morita, M., Tsuruta, N. and Morita, K., 1993. Activation of wood surface by corona treatment to improve adhesive bonding. J. Appl. Polym. Sci, 49(7): 1251-1258. - Talaei, A. Rezvani, M. and Doost Mohammadi, M., 2018. Investigation of Adhesion Strength of Alkyd and Nitro Cellulose Transparent Coatings in Different Heat-treated Poplar Wood. Journal of color science and technology, 12: 171-180. - Tshabalala, M. and Gangstad, J., 2003. Accelerated Weathering of Wood Surfaces Coated with multifunctional Alkoxysilanes by Sol-Gel Deposition. J Coat Technol, 75: 37-43. - Tuck, N., 2000. Waterborne and Solvent Based Alkyds and Their End User Applications. John Wiley & Sons in Association with SITA Technology Ltd Press, London. - Uehara, T. and sakata, L., 1990. Effect of corona discharge treatment on celluloseprepared from beech wood. J appl Polym Sci, 41 (7/8): 1695-1706. - Veronovski, N., Verhovsek, D. and Godnjavec, J., 2013. The influence of surface-treated nano-TiO2 (rutile) incorporation in water-based acrylic coatings on wood protection. Wood Sci Technol, 47: 317-328. - Yamamoto. A., Kymäläinen. M., Lindroos. T., Rohumaa. A., Sokka. K. and Rautkari. L., 2017. Surface Activation of Wood by Corona Treatment and NaOH Soaking for Improved Bond Performance in Plywood. BioResources, 12(4): 9198-9211. | ||
|
Statistics Article View: 658 PDF Download: 439 |
||
Journal management system. designed by sinaweb