| تعداد نشریات | 282 |
| تعداد نشریات سازمان | 80 |
| تعداد شمارهها | 3,208 |
| تعداد مقالات | 35,560 |
| تعداد مشاهده مقاله | 53,001,338 |
| تعداد دریافت فایل اصل مقاله | 92,287,523 |
مطالعه آزمایشگاهی سرریز کلید پیانویی با تغییر نسبت عرض کلیدها | ||
| تحقیقات مهندسی سازه های آبیاری و زهکشی | ||
| مقاله 5، دوره 20، شماره 77، بهمن 1398، صفحه 57-72 اصل مقاله (1.46 M) | ||
| نوع مقاله: مقاله پژوهشی | ||
| شناسه دیجیتال (DOI): 10.22092/idser.2019.125665.1380 | ||
| نویسندگان | ||
| سید محمد حسن سعیدی1؛ مجید رحیم پور* 2؛ محمد ذونعمت-کرمانی2؛ محمدرضا مددی3 | ||
| 1دانش آموخته کارشناسی ارشد بخش مهندسی آب، دانشکده کشاورزی، دانشگاه شهید باهنر کرمان، کرمان، ایران | ||
| 2دانشیار بخش مهندسی آب، دانشکده کشاورزی، دانشگاه شهید باهنر کرمان، کرمان، ایران | ||
| 3استادیار گروه مهندسی آب، دانشکده کشاورزی، دانشگاه جیرفت، جیرفت، ایران | ||
| چکیده | ||
| سرریز کلید پیانویی سازهای است که سطح و دبی جریان را تنظیم میکند و قابلیت استقرار در مخازن سدها و کانالها را داراست. ویژگی اصلی این سرریز توانایی عبور دادن دبی زیاد بهازای بار آبی اندک است. این نوع سرریز با توجه به خصوصیات هندسی، در چهار نوع A، B، C و D طبقه بندی میشود. در پژوهش حاضر برای بررسی تأثیر عرض کلیدهای ورودی و خروجی بر مشخصههای هیدرولیکی جریان، 16 مدل فیزیکی از سرریزهای کلید پیانویی نوع A و D ساخته شد. برای دستیابی به اهداف این پژوهش، بیش از 300 آزمایش روی یک کانال آزمایشگاهی اجرا و نشان داده شد که بهازای بار آبی مشخص، سرریز نوع A، نسبت به سرریز نوع D، ظرفیت تخلیه بالاتری دارد. همچنین معلوم شد هندسۀ خاص سرریز نوع A ، مانع تشکیل پدیدۀ مخرب جریان موجکی روی آن میشود. بر اساس یافتههای پژوهش، مشخص شد که مدل سرریز با نسبت عرض کلیدهای ورودی به خروجی برابر 66/1، در مقایسه با مدلهای دیگر، تا 30 درصد عملکرد بهتری دارد. | ||
| کلیدواژهها | ||
| ابعاد هندسی؛ اندازهگیری جریان؛ مدل فیزیکی؛ مشخصه های جریان | ||
| عنوان مقاله [English] | ||
| Experimental Study of Piano Key Weir by Changing Width Ratio of the Keys | ||
| نویسندگان [English] | ||
| S. Mohammad Hassan Saeidi1؛ Majid Rahimpour2؛ Mohammad Zounemat-Kermani2؛ Mohamad Reza Madadi3 | ||
| 1Shahid Bahonar University of Kerman | ||
| 2Associate Professor, Shahid Bahonar University of Kerman | ||
| 3Assistant Professor, Department of Water Engineering, University of Jiroft | ||
| چکیده [English] | ||
| Introduction Piano key weir (PKW) is a hydraulic structure that can be installed at dams and canals for regulating the flow surface and discharge. The main feature of this weir is the ability to pass a large flow of water over a small head. Regarding its geometrical properties, this weir is classified into four types of A, B, C and D. PKW with symmetrical upstream and downstream overhangs is classified as Type A, one with only upstream overhangs as Type B, one with only downstream overhangs as Type C, and one without overhangs as Type D. Despite various studies on piano key weirs (some of which were mentioned in the text), the flow behaiviour over these structures is very complex, unpredictable and three-dimensional. So further laboratory investigations on PKWs are needed. In the present study, the effect of the width of the inlet and outlet keys on the hydraulic characteristics of these weirs is investigated. In addition, the occurrence of undular flow on these types of weirs is reported for the first time. To achieve the aims of this study, more than 300 experiments were conducted at a laboratory flume. Methodology The experimental tests of this research were conducted in the hydraulic & water structures laboratory of Shahid Bahonar University of Kerman, on a laboratory flume with 8 m length, 80 cm width and 60 cm height, having glass walls and metal bottom. The flow discharge was adjusted in a range of 5 to 60 liters per second by a valve. In total, 16 physical models of PKW-A and PKW-D weirs were constructed to investigate the effect of width of inlet and outlet keys on the hydraulic characteristics of flow over such weirs. Seven discharges were tested for each model of weirs, and experiments were repeated three times for each discharge. Results and Discussion The results demonstrated that at low water loads (Ht <3cm), both types of weirs have almost the same performance. But as the water load increases, the performance of PKW-A weir deviates from the type PKW-D weir, i.e. it was able to pass larger discharges for an identical flow head. The superiority of PKW-A weir was more evident in small inlet-to-outlet ratios of keys. For low flow heads, the performance of weirs with different Wi/Wo ratios in terms of discharge capacity is almost similar. Anderson and Tullis (2013) found similar results in their experiments. At higher flow heads, the PKW-A1.66, compared to other models, had the largest discharge capacity in same flow heads, indicating its better performance. At maximum flow head (5.5cm), this weir was able to discharge 52 liters per second, which is 24% more than PKW-A0.6 weir. Similar trend exists for D-type piano key weirs. It was observed that undular flow is formed on D-type piano key weirs. Although, this phenomenon was previously observed on rectangular broad-crested weirs (Chanson, 1976; Madadi et al, 2013), but for the piano key weirs, this is the first report on formation of undular weir flow above D-type PKW. Conclusions According to the results of this study, the ratio of the width of the inlet keys to the width of the outlet keys is a very effective parameter in the discharge capacity of the piano key weirs, and the presence of a forehead can also play a role in enhancing the performance of the weir. Also, the results indicated that for a given head, not only the A-type PKW has more discharge capacity comparing to D-type weir, but also due to its special geometry, the undular flow phenomenon cannot be formed above such weir. Furthermore, the PKW weir with inlet to outlet key width ratio of 1.66 demonstrated 30% higher performance comparing to the other investigated models. | ||
| کلیدواژهها [English] | ||
| Flow Characteristics, Flow Measurement, Geometrical Dimensions, Physical Model | ||
| مراجع | ||
|
Anderson, R. M., & Tullis, B. P. (2011). Influence of piano key weir geometry on discharge. In International Conference of Labyrinth and Piano Key Weirs. Feb. 9-11. At Liège, Belgium.
Anderson, R. M., & Tullis, B. P. (2013). Piano key weir hydraulics and labyrinth weir comparison. Journal of Irrigation and Drainage Engineering, 139, pp. 246-253.
Chanson, H. (1996). Free-surface flows with near-critical flow conditions. Canadian Journal of Civil Engineering, 23(6), pp. 1272-1284.
Cicero, G. M., Vermeulen, J., & Laugier, F. (2016). Influence of some geometrical parameters on Piano Key Weir dischargeefficiency. In 6th IAHR International Symposium on Hydraulic Structures. June 27-30. Portland.
Kabiri-Samani, A., & Javaheri, A. (2012). Discharge coefficients for free and submerged flow over piano key weirs. Journal of Hydraulic Research, 50(1), pp. 114-120.
Khanh, M., & Hien, T. C. (2013). Research on the discharge capacities of piano key weirs type A, D and rectangular labyrinth (in Vietnamese). In 13th Conference on Science and Technology. Nov. 27 - 29. HCMUT–Faculty of Civil Engineering, Vietnam.
Laugier, F. (2007). Design and construction of the first piano key weir spillway at goulours dam. International Journal of Hydropower Dams, 13, pp. 94-100.
Laugier, F. (2009). Design and construction of a labyrinth PKW spillway at Saint-Marc dam, France. International Journal Hydropower Dams, 15(5), pp. 100-107.
Lempérière, F., & Ouamane, A. (2003). The piano keys weir: a new cost effective solution for spillways, hydropower and dams. Official Journal of the International Hydropower Association, 10, pp. 144-149.
Machiels, O. (2012). Experimental study of the hydraulic behaviour of piano key weirs (M. Sc. Thesis) Université de Liege, Liege, Belgium. Machiels, O., Pirotton, M., Archambeau, P., Dewals, B., & Erpicum, S. (2014). Experimental parametric study and design of piano key weirs. Journal of Hydraulic Research, 52(3), pp. 326-335.
Madadi, M. R., Dalir, A. H., & Farsadizadeh, D. (2013). Control of undular weir flow by changing of weir geometry. Flow Measurement and Instrumentation, 34, pp. 160-167.
Ribeiro, M. L., Bieri, M., Boillat, J. L., Schleiss, A. J., Singhal, G., & Sharma, N. (2012). Discharge capacity of piano key weirs. Journal Hydraulic Engineering, 138, pp. 199-203.
Yarmohammadi, B., & Ahadiyan, J. 2016. Experimental study of flow hydraulic in piano key weirs at different parapet wall. Journal of Irrigation Sciences and Engineering, 39(4), pp. 47-58. (in Persian) | ||
|
آمار تعداد مشاهده مقاله: 777 تعداد دریافت فایل اصل مقاله: 507 |
||