A Study on the Possibility of Extraction, Identification and Removal of Metallic Ions and Resins in Bleached Bagass Pulp by ECF Stages | ||
| تحقیقات علوم چوب و کاغذ ایران | ||
| Article 7, Volume 30, SPRING 1 - Serial Number 50, May 2015, Pages 72-84 PDF (421.84 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.22092/ijwpr.2015.10777 | ||
| Authors | ||
| Ramin Veisi* 1; Iman Khajeh ali2 | ||
| 1Associate Professor, Department of Wood and Paper Technology, Islamic Azad University of Chalous, Mazandaran, Iran | ||
| 2Graduated in Wood and Paper Technology, Islamic Azad University of Chalous, Iran | ||
| Abstract | ||
| This study and it aim was accomplished on extraction, identification and removal of metallic ions and resins in bleached Bagass pulp by ECF stages. For this purpose, the samples were randomly selected from soda unbleached pulp of Pars mill. The first, pulp flour provided and measured ash and extractive percent by the TAPPI standards. Then the mineral compounds dissolved in 65% nitric acid and the mineral compounds of pulps identificated by Atomic adsorption method. The results of this study showed that the most of Pb, Cu, Zn ions were in H2O2 bleached pulp, the most of Ni ion in OD(Ep)P stage and the most of Fe ion in unbleached soda pulp. The results showed that OD(Ep)D stage decrease Fe ion and EH stage decrease Ni, Cu and Zn ions in pulps. The results of GC-MS diagram showed that 35 compounds were identified in unbleached soda pulp after cooking, that 1,2-Benzendicarboxylic acid, Hexadecanoic acid, Hexadecan, Octadecan, p-Xylene, 4-Hydroxy-4-Methyl-2-Pantanone,Ethylbenzen and Dodecan were important chemical components in samples. In generally, 17,12 and 14 compounds were identified in EH, OD(Ep)P and OD(Ep)D bleaching stages, respectively, so that, 1,2-Benzendicarboxylic acid and p-Xylene were 2 common and important chemical components in all samples and Octadecan and 9-Dodecanoic acid remove as two components from pulps after bleaching, too. The results showed that EH, OD(Ep)P and OD(Ep)D bleaching stages were very important in bleaching, removal of chemical components and brightness stability of soda pulps. | ||
| Keywords | ||
| bleaching; Atomic Adsorption; GC-MS; Bagass; Metallic Ions | ||
| References | ||
|
-Abdul Kh.. 2010. Development and material properties of new hybrid plywood from oil palm biomass, Journal of Tropical forest products, 3(1),417-424. -Barzan A., Soraki, S., 2002. Procedure of experimental for pulp and paper, Mazandaran Wood and Paper Industries, Sari, Iran, 111, (in Persian). -Cater, Henry A., 1996. The Chemistry of paper preservation, Journal of Chemical Education, vol. 73, No. 11. -Holmbom, B., 1977. Improve gas chromatographic analysis of faty and resin acid mixtures with special reference to tall oil, JAM oil chem. soc 54:284-243. -Johansson M., 2000. Formation of Chromospheres and Leucochromopheres during manufacturing of mechanical pulp, Department of pulp and paper chemistry and technology, Royal Institute of Technology, Stockholm, Sweden. -Lim, S.C. and Fujii, T., 1997. A note on structure of oil palm trunk by scanning electron microscopy, Journal of Tropical forest products, 3 (1),105-109. -Mirshokraei, S.A., 2002. Wood chemistry, Tehran, press. 194 p. (Translated in Persian). -Mirshokraie S.A. and Abdolkhani A., 2005. Effects of metallic ions on brightness CMP pulp of Hard woods of north of Iran, Iranian Journal national resourse,58 (2), (in Persian). -Qiu, Z., Ni, Y. and Yang S., 2003. Using DTPA to decrease manganese induced peroxide ecomposition, J. Wood. Chem. Technol. 23(1), 1-11. - Razi M., 2001. Effects of washing and deinking on metallic ions and organically chemical components in tissue papers, M.Sc. Thesis, College of Natural Resources, Islamic Azad University of Chalous. 86P, (in Persian). -Rahmani, H. and Abdolkhani, A., 2010. Characterization and removal of resins from mixed tropical hardwoods. Iranian Journal of Wood and Paper Industries .1(1)1. 45-46, (in Persian). -Seth, R.S., 1995. The effects of fiber length & coarseness on the tensile strength of webs, TAPPI J., N0:3. -Technical Association of Pulp and Paper Industry, 2009. Standard Test Methods. Tappi Press, tlanta, GA. USA. - Vaysi, R., 2011. Identification of the extractives chemical compounds in newsprints by GC-MS methods, Asian journal of chemistry, 23(11). -Vichnesky, S., Fuhr, B. and Melnichuk, J., 2003. Characterization of wood and non-wood mechanical pulps by differential thermal analysis, J. Pulp and Paper Sci. 29(1), 17-20. | ||
|
Statistics Article View: 2,077 PDF Download: 1,298 |
||
Journal management system. designed by sinaweb