Morphological Characteristics and Chemical Composition of Grapevine Branches (Vitis vinifera spp.) Grown in Astara | ||
| تحقیقات علوم چوب و کاغذ ایران | ||
| Article 1, Volume 30, WINTER 4 - Serial Number 53, December 2015, Pages 525-537 PDF (403.5 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.22092/ijwpr.2015.102670 | ||
| Authors | ||
| Seyyed Pedram Hashemi Beygzadmahalleh1; Seyyed Peyman Hashemi Beygzadmahalleh* 1; Asghar Tabei2 | ||
| 1Academic Staff, Department of Wood and Paper Science and Technology, Young Researchers Club, Islamic Azad University, Astara Branch, Iran. | ||
| 2Assistant professor, Department of Wood and Paper Science and Technology, Young Researchers Club, Islamic Azad University, Astara Branch, Iran | ||
| Abstract | ||
| This study has been conducted to determine morphological characteristics of fibers and amount of chemical components of grapevine branches cultivated in Astara in province of Guilan. For this purpose the number of 53 branches, with same size and diameter, were cut from some grapevine and sent to laboratory of wood and paper industries in Islamic Azad university Astara branch. To separate the fibers and for studying their morphological characteristics, wooden chip sampling from the branches was conducted at 3 heights of them (5%, 50% and 75%). Fiber separation was done by method (Franklin 1954) and then dimensions of fibers and their biometric coefficients were determined. From a number of separated branches, wood flour was prepared in two modes of with skin and without skin and then, percentage of chemical components of them was determined according to TAPPI standard. The overall average percentage of holocellulose, alpha cellulose, hemi cellulose, cellulose, lignin, acetone extractives, alcohol extractives, hot water extractives, cold water extractives and ash were measured as 87.59, 56.99, 30.59, 47.20, 25.16, 5.90, 2.53, 4.41, 1.79 and 1.79 percent, respectively. Also, the total average of fiber length, fiber diameter, lumen diameter and cell wall thickness were measured as 0.96 mm, 26.45 µm, 15.48 µm and 5.49 µm, respectively. Also, the total average of slenderness, flexibility and runkel coefficients were calculated as 36.29, 58.50 and 0.71, respectively. The results showed that, in the debarked branches of grapevine trees, the amounts of holocellulose, alpha cellulose, hemi cellulose and cellulose are more than with skin branches and debarked branches have less lignin, extractives and ash than with skin branches. Also. The results showed that dimensions of the fibers including fiber length, fiber diameter and fiber lumen diameter, except cell wall thickness, decreased with increasing of height. | ||
| Keywords | ||
| Keywords: Grapevine Branches; Morphological characteristics; Chemical components; Astara | ||
| References | ||
|
- Ates, S., Ni,Y., Akgul, M. and Tozluoglu, A., 2008. Characterization and evaluation of Paulownia elongate as a raw material for paper production. African Journal of Biotechnology (7), 22, pp: 4153-4158. -Bendtsen, B.A., 1978. Properties of wood from improved and intensively managed trees. For. Prod. J. 28(10), pp: 61-72. -Brit Kenneth, W., 1970. A hand book of pulp and paper technology. Second Edition. Van Nostrand Reinhold Company New York, 327. -Dadswell, H.E., Wardrop, A.B. and Watson, A.J., 1958. The morphology, hemistry and pulping characteristics of reaction wood. In Fundamentals of Papermaking Fibers, ed. K Bolam. London: British Paper and Board Makers Association, pp: 187-229. -Deniz, I. and Ates, S., 2002. Determination of optimum kraft pulping conditions using bamboo (Pyllotachys bambusoides). 2nd. National Black Sea Forestry Congress Proceedings, Artvin, Turkey, pp: 1072-1084 - Dinwoodie, J.M., 1965. The relationship between fiber morphology and paper properties. A review of literature, Tappi (48), pp: 440–447. - Enayati, A.A., Hamzeh, Y., Mirshokraie, S.A. and Molaii, M., 2009. "Papermaking potential of canola stalks," BioRes. (1) 4, pp: 245-256. - Ebrahimpour Kasmani, J., Samariha, A. and Kiaei, M., 2011. Effects of agricultural residues on biometry, chemical and morphological properties and use in paper making industrial. Middle – east Journal of Scientific Research, 7 (6),pp: 844 – 850. - Fengel, D. and Wegener, G., 1984. Wood: chemistry, ultra structure, reactions/Dietrich W. de Gruyter, Berlin; New York, pp: 26-65. - Franklin, G.L., 1954. Preparation of thin sections of synthetic resins and wood-resin composites, and a new macerating method for wood. Nature (155), pp: 51–59. - Hassanimehr, S., 2011. Studying the structure of rural residential areas related to important geographic factors in villages of Astara. Journal of Natural Geography, (3) 9. -Horn, R.A., 1974. Morphology of pulp fiber from softwoods and influence on paper strength. USDA Forest Service. Research Paper FPL 312, FOR. Prod. Lab, Madison, WI, USA. -Horn, R.A., 1978. Morphology of pulp fiber from hardwoods and influence on paper strength. USDA Forest Service. Research Paper FPL 242, FOR. Prod. Lab, Madison, WI, USA. - Hurter, R.W. and Riccio, F.A., 1998. Why CEOS don’t want to hear about nonwoods—or should they? In: TAPPI Proceedings, NA Nonwood Fiber Symposium, Atlanta, GA, USA, pp: 1–11. -Kellogg, R.M. and Thykeson, E., 1975. Predicting kraft mill paper strength from fiber properties. Tappi 58 (4), pp:131-135. -Madakadze, I.C., Radiotis, T., Li, J., Goel, K. and Smith, D.L., 1999. Kraft pulping characteristics and pulp properties of warm season grasses. Bioresour. Technol 69 ,pp: 75-85. -Matolcsy, G.A., 1975. Correlation of fiber dimensions and wood properties with the physical properties of kraft pulp of Abies balsamea L. (Mill.). Tappi 58 (4), pp: 136-141. - McDougall, G.C., McDougall, G.J., Morrison, I.M., Stewart, D., Weyers, J.D.B. and Hillman, J.R., 1993. Plant fibres: botany, chemistry and processing. Journal of the Science of Food and Agriculture (62): 1-20. - Ogbonnaya, C.I., Roy-Macauley, H., Nwalozie, M.C. and Annerose, D.J.M., 1997. Physical and histochemical properties of kenaf (Hibiscus cannabinus L.) grown under water deficit on a sandy soil. Ind. Crops Prod. (7), pp: 9–18. -Oluwadare, A.O. and Ashimiyu Sotannde, O., 2007. The Relationship Between Fibre Characteristics and Pulp-sheet Properties ofLeucaena leucocephala(Lam.) De Wit. Middle-East Journal of Scientific Research 2 (2), pp: 63-68. -Osadare, A.O., 2001. Basic wood and pulp properties of Nigerian-grown Caribbean pine (Pinus caribaea Morelet) and their relationship with tree growth indices. Ph.D. thesis University of Ibadan, 347. -Parshin, A. and Dezeeuw, C., 1980. Textbook of Wood Technology. 4th edition. McGraw – Hill, New York. - Safdari, V.R., 2010. Morphological characteristics and chemical components of Ulmus glabra, Ulmus compestris, Zelkova carpinifolia, Celtis australis woods, Journal of Wood and Paper Science Research, Volume 25, Number (2), pp: 248- 259. - Safdari, V.R., Hashemi, S.P., Hoseyni Hashemi, S.KH. and Tabei, A., 2012. Potential of tobacco's stalk (Nicotiana tabacum L. 'PVH19') as a raw material in lignocellulosic industry, Journal of Natural Resources, Science and Technology, Volume 7, Number (1), pp: 87 - 99. - Safdari, V.R., Hashemi, S.P., Tabei, A. and Hoseyni Hashemi, S.KH., 2012. Anatomical, morphological and chemical components of tobacco's stalk )Nicotiana tabacum L. 'Coker 347'), Journal of Wood and Paper Science Research, Volume 27, Number (3), pp: 495- 509. - Samariha, A. and Khakifirooz, A., 2011. "Application of NSSC pulping to sugarcane bagasse. Bioresaurce (3) 6: 3313-3323. -Seth, R.S. and Page, D.H., 1988. Fiber Properties and tearing resistance. Tappi J. 71 (2), pp:103 – 107. - Shiyarkar, I., Tabei, A., and Farajpoor, A., 2013. Morphological characteristics and chemical components of two corn varieties (Oilseeds and 704) stalks cultivated in Astara. Journal of Wood and Paper Science Research, Volume 28, Number (3), pp: 561- 582. -Tutus, A., Comlekcioglu, N., Karaman, S. and Alma, M.H., 2010. Chemical composition and fiber properties of Crambe orientalis and Crambe tataria. Int. J. Agric. Biol., (12) pp: 286–290. - Ulotuah, O.F., 2006, Suitability of some local bast fibre plants in pulp and paper making. Journal of Biological Sciences (3) 6, pp: 635-637. - Usta, M., Kırcı, H. and Eroglu, H., 1990. Soda- Oxygen pulping of corn (Zea mays indurata sturt). In: Tappi Pulping Conference: Toronto, Ontario, Canada, Proceeding Book (1), pp: 307-312. - Ververis, C., Georghiou, K., Christodoulakis, N., Santas, P. and Santas, R., 2004. Fiber dimensions, lignin and cellulose content of various plant materials and their sutibality for paper production. Industrial Crops and Products (19) pp: 245–254. -Watson, A.J. and Dadswell, H.E., 1961. Influence of fiber morphology on paper properties. Part. Fibre Length, APPITA, 14. No. 5, CSIRO, Australia, 168-178. - Xu, F., Zhong, X.C., Sun, R.C. and Lu, Q., 2006. “Anatomy, ultrastructure, and lignin distribution in cell wall of Caragana Korshinskii,” Industrial crop and production (24), pp: 186-193. | ||
|
Statistics Article View: 18,122 PDF Download: 1,432 |
||
Journal management system. designed by sinaweb